Self setting of Remote IP

Internet MCU W7500x-S2E
1

Hi to all.
In UDP communication mode, I was expecting that Remote IP address was set automatically by using the latest source IP address of a received packet. Instead it looks like host PC needs to set on the fly the Remote IP parameter with its own Ip address. This will not allow to have multiple hosts that polls not too often the W7500-S2E based device with a request-reply based protocol.

Is there a way to activate this autoset of Remote IP? Is there a plan for a firmware update that allows this?

Thanks

1 Like
2

Dear TizioM,

The features you mentioned are currently implemented and readily available. :slight_smile:

Please refer to UDP 1: N mode in the following link.
https://wizwiki.net/wiki/doku.php?id=products:wiz750sr:usermanual:start#udp_mode

Regards,
Eric